RP/0/RSP0/CPU0:router# show l2tpv2 statistics | file tftp: vrf vrf1 |
RP/0/RSP0/CPU0:router# show l2tpv2 tunnel accounting statistics | file tftp: vrf vrf1 |
Show output for l2tpv2 session:
Sun Dec 4 22:37:48.554 PST
Session id 46362 is up, tunnel id 58775, logical session id 131086
Remote session id is 16, remote tunnel id 54970
Locally initiated session
Call serial number is 2062300015
Remote tunnel name is ios_lns
Internet address is 3.3.3.4
Local tunnel name is blah_client_auth_id
Internet address is 1.1.1.1
IP protocol 17
Session is L2TP signaled
Session state is established, time since change 00:06:56
UDP checksums are enabled
Sequencing is off
Conditional debugging is disabled
Unique ID is 0
Session username is user3_vpdn@domain.com
Interface GigabitEthernet0_0_0_1.pppoe14
Show output for l2tpv2 tunnel detail:
Mon Dec 5 20:37:55.891 PST
Tunnel id 133 is up, remote id is 15705, 1 active sessions
Locally initiated tunnel
Tunnel state is established, time since change 6d09h
Tunnel transport is UDP (17)
Remote tunnel name is IOS_LNS
Internet Address 3.3.3.3, port 1701
Local tunnel name is XR_LAC
Internet Address 1.1.1.1, port 1701
VRF name: default
Tunnel group id
L2TP class for tunnel is VPDN_3.3.3.3
Control Ns 9205, Nr 342
Local RWS 512 (default), Remote RWS 1024
Control channel Congestion Control is disabled
Tunnel PMTU checking disabled
Retransmission time 1, max 1 seconds
Unsent queuesize 0, max 0
Resend queuesize 0, max 2
Total resends 0, ZLB ACKs sent 340
Total out-of-order dropped pkts 0
Total out-of-order reorder pkts 0
Total peer authentication failures 0
Current no session pak queue check 0 of 5
Retransmit time distribution: 0 0 0 0 0 0 0 0 0
Control message authentication is disabled
Related Commands
DescriptionCommand
Configures the l2tp class.l2tp-class, on page 412
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
429
PPPoE LAC-Specific Commands
show l2tpv2
To Next Page
Loading...
Need help?
General
