EasyManuals Logo

Cisco A9K-SIP-700 Command Reference

Cisco A9K-SIP-700
590 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #463 background imageLoading...
Page #463 background image
Setting a value of 0 for delay means that no transmission delay is set for the PADO message. Setting a value
of 10000 means that an infinite delay is set for PADO message; or, in other words, the PADO message is
never sent.
Within the category of service-name matches, full string matches are preferred to sub-string matches. If more
than one sub-string match occurs, the selection is based on a random order.
If there is neither a string match nor a sub-string match, the configured Circuit-ID delay is used (if a Circuit-ID
is present in PADI message), followed by the configured Remote-ID delay (if a Remote-ID is present in PADI
message).
If there are no matches, the configured pado delay is used for the PADO message.
Task ID
OperationTask ID
read, writeppp
Examples
This example shows how to configure a delay of 8000 milliseconds for the PADO message, if the Service-Name
received in the PADI message exactly matches the configured string (service1 in this example):
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pppoe bba-group bba1
RP/0/RSP0/CPU0:router(config-bbagroup)# pado delay service-name string service1 8000
This example shows how to configure a delay of 5000 milliseconds for the PADO message, if the Service-Name
received in the PADI message contains the configured string (service in this example):
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pppoe bba-group bba1
RP/0/RSP0/CPU0:router(config-bbagroup)# pado delay service-name contains service 5000
Related Commands
DescriptionCommand
Configures a specific delay for PPPoE PADO message for a PPPoE
BBA-Group in BNG.
pado delay, on page 442
Configures a delay for PPPoE PADO message for a PPPoE BBA-Group
in BNG, based on the Circuit-ID received in PADI message.
pado delay circuit-id, on page 444
Configures a delay for PPPoE PADO message for a PPPoE BBA-Group
in BNG, based on the Remote-ID received in PADI message.
pado delay remote-id, on page 446
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
449
PPPoE Commands
pado delay service-name

Table of Contents

Other manuals for Cisco A9K-SIP-700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco A9K-SIP-700 and is the answer not in the manual?

Cisco A9K-SIP-700 Specifications

General IconGeneral
BrandCisco
ModelA9K-SIP-700
CategoryNetwork Router
LanguageEnglish

Related product manuals