Command Modes
PPPoE BBA-Group configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
The pppoe sessions throttle support was extended for circuit-id, remote-id,
inner-vlan, outer-vlan, vlan and circuit-id-and-remote-id
Support for the variables, request-count, request-period and blocking-period
was added.
Release 4.3.1
Usage Guidelines
If both mac access-interface throttle and mac-iwf access-interface throttle are configured, only IWF throttle
is used for IWF sessions, so that different throttling can be applied to IWF and non-IWF sessions.
Task ID
OperationTask ID
read, writeppp
Examples
This example shows how to configure a throttle for pppoe sessions for each circuit-id in a PPPoE BBA-Group:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pppoe bba-group bba1
RP/0/RSP0/CPU0:router(config-bbagroup)# sessions circuit-id throttle 1000 50 25
This example shows how to configure a throttle for IWF session requests for each peer mac-address under
individual access-interface in a PPPoE BBA-Group:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pppoe bba-group bba1
RP/0/RSP0/CPU0:router(config-bbagroup)# sessions mac-iwf access-interface throttle 5000 100
50
Related Commands
DescriptionCommand
Configures a limit for PPPoE sessions for a PPPoE BBA-Group
in BNG.
pppoe sessions limit, on page 457
Shows the throttle information for the PPPoE sessions.show pppoe throttles, on page 475
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
461
PPPoE Commands
pppoe sessions throttle
To Next Page
Loading...
Need help?
General
