Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
This command is available only in the dynamic template type ppp submode.
Task ID
OperationTask ID
read, writeqos
Examples
This is an example of configuring the qos account command in dynamic template configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp p1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# qos account AAL5 snap-rbe
Related Commands
DescriptionCommand
Sets the minimum guaranteed output bandwidth for
a subscriber.
qos output minimum-bandwidth, on page 482
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
481
QOS Commands
qos account