Specifies member of bundle interface or pin-down
(generic list) interface of PWHE interface.
This keyword is applicable only for bundle
and PWHE interface.
Note
member
(Optional) Specifies the host-link.
This keyword is applicable only for satellite
information.
Note
host-link
(Optional) Displays detailed QoS information for the
designated node. The node-id argument is entered
in the rack/slot/module notation.
location node-id
Command Default
No default behavior or values
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 3.7.2
The command was supported in dynamic template configuration mode in BNG.Release 4.3.0
The show qos interface command output was updated to display Flow Aware
call admission control (CAC) and user based rate limiting (UBRL) information.
The show qos interface command output was updated to display QoS Offload
on satellite information.
PWHE interface type PW-Ether and PW-IW were added.
The show output was updated for PWHE interface details.
Release 5.1.1
Usage Guidelines
The show qos interface command displays configuration for all classes in the service policy that is attached
to an interface.
Use this command to check the actual values programmed in the hardware from the action keywords in the
police rate command.
(Only BNG) To enter the dynamic template configuration mode, run dynamic-template command in the
Global Configuration mode.
Task ID
OperationsTask ID
readqos
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
495
QOS Commands
show qos interface (BNG)
To Next Page
Loading...
Need help?
General
