Command History
ModificationRelease
This command was introduced.Release 3.7.2
The command was supported in dynamic template configuration mode
in BNG.
The np keyword was introduced.
Release 4.3.0
PWHE interface type PW-Ether and PW-IW were added.Release 5.1.1
Usage Guidelines
To enter the dynamic template configuration mode, run dynamic-template command in the Global
Configuration mode.
Task ID
OperationsTask ID
read, writeqos
Examples
This example shows the results of the command to show interfaces at location 0/1/CPU0 for a
shared-policy-instance:
RP/0/RSP0/CPU0:router# show qos summary shared-policy-instance bundlespi location 0/1/CPU0
output
List of interfaces/NPs retrieved
GigabitEthernet0/1/1/1 (member of Bundle-Ether1.1)
GigabitEthernet0/1/1/2 (member of Bundle-Ether1.1)
This example shows policer interface statistics of BVI interface at location 0/5/cpu0:
RP/0/RSP0/CPU0:router# show qos summary police interface bvi 1 output location 0/5/cpu0 np
np1
Legend:
=======
1. Policer ID is displayed in HEX.
2. A '*' against the counter means the action is drop.
3. Conform displays match counter for non-policer leaf.
Policy:Class PoliceID Conform Exceed Violate
BVI1 NP1
foo
:dscp48 6145 0 0* 0*
foo
:class-default 6146 0 0* 0*
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
507
QOS Commands
show qos summary BNG
To Next Page
Loading...
Need help?
General
