Cisco Catalyst 3560-X

1-26
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring IP Unicast Routing
Configuring RIP
Beginning in privileged EXEC mode, follow these steps to disable split horizon on the interface:
To enable the split horizon mechanism, use the ip split-horizon interface configuration command.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Enter interface configuration mode, and specify the interface to
configure.
Step 3
ip address ip-address subnet-mask Configure the IP address and IP subnet.
Step 4
no ip split-horizon Disable split horizon on the interface.
Step 5
end Return to privileged EXEC mode.
Step 6
show ip interface interface-id Verify your entries.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.