Cisco Catalyst 3560-X User Manual

1-6
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring SNMP
Configuring SNMP
Note The switch might not use sequential values within a range.
Configuring SNMP
• Default SNMP Configuration, page 1-6
• SNMP Configuration Guidelines, page 1-7
• Disabling the SNMP Agent, page 1-7
• Configuring Community Strings, page 1-8
• Configuring SNMP Groups and Users, page 1-9
• Configuring SNMP Notifications, page 1-12
• Setting the Agent Contact and Location Information, page 1-16
• Limiting TFTP Servers Used Through SNMP, page 1-17
• SNMP Examples, page 1-17
Default SNMP Configuration
Physical (such as Gigabit Ethernet or SFP
2
-module interfaces) based
on type and port numbers
10000–14500
Null 10501 (nonstackable switches)
14501 (stackable switches)
Loopback and Tunnel 24567 +
1. SVI = switch virtual interface
2. SFP = small form-factor pluggable
Table 1-3 ifIndex Values (continued)
Interface Type ifIndex Range
Table 1-4 Default SNMP Configuration
Feature Default Setting
SNMP agent Disabled
1
.
1. This is the default when the switch starts and the startup configuration does not have any snmp-server global configuration
commands.
SNMP trap receiver None configured.
SNMP traps None enabled except the trap for TCP connections (tty).
SNMP version If no version keyword is present, the default is Version 1.
SNMPv3 authentication If no keyword is entered, the default is the noauth (noAuthNoPriv)
security level.
SNMP notification type If no type is specified, all notifications are sent.

Cisco Catalyst 3560-X Specifications

General

Enclosure Type	Rack-mountable - 1U
Subtype	Gigabit Ethernet
Ports	48 x 10/100/1000 + 4 x SFP
Flash Memory	64 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Operating System	Cisco IOS
Device Type	Switch
Performance	Switching capacity: 128 Gbps
Jumbo Frame Support	Yes
Routing Protocol	RIP-1, RIP-2, EIGRP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, HTTP, HTTPS
Features	DHCP support, VLAN support, QoS, IPv6 support, Syslog
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.1p, IEEE 802.3af, IEEE 802.3x, IEEE 802.3ad, IEEE 802.1w, IEEE 802.1x, IEEE 802.1s, IEEE 802.3ah, IEEE 802.1ag, IEEE 802.3at
Stacking	Stackable
Security Features	SSH, RADIUS, TACACS+
Management	CLI
Dimensions (H x W x D)	17.5 in
Operating Temperature	32 to 113 °F (0 to 45 °C)
Humidity	10 - 95% (non-condensing)