1-21
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Appendix 1 Working with the Cisco IOS File System, Configuration Files, and Software Images
Working with Configuration Files
Understanding Configuration Replacement and Rollback
• Archiving a Configuration, page 1-21
• Replacing a Configuration, page 1-21
• Rolling Back a Configuration, page 1-22
Archiving a Configuration
The configuration archive provides a mechanism to store, organize, and manage an archive of
configuration files. The configure replace privileged EXEC command increases the configuration
rollback capability. As an alternative, you can save copies of the running configuration by using the copy
running-config destination-url privileged EXEC command, storing the replacement file either locally
or remotely. However, this method lacks any automated file management. The configuration replacement
and rollback feature can automatically save copies of the running configuration to the configuration
archive.
You use the archive config privileged EXEC command to save configurations in the configuration
archive by using a standard location and filename prefix that is automatically appended with an
incremental version number (and optional timestamp) as each consecutive file is saved. You can specify
how many versions of the running configuration are kept in the archive. After the maximum number of
files are saved, the oldest file is automatically deleted when the next, most recent file is saved. The show
archive privileged EXEC command displays information for all the configuration files saved in the
configuration archive.
The Cisco IOS configuration archive, in which the configuration files are stored and available for use
with the configure replace command, is in any of these file systems: FTP, HTTP, RCP, TFTP.
Replacing a Configuration
The configure replace privileged EXEC command replaces the running configuration with any saved
configuration file. When you enter the configure replace command, the running configuration is
compared with the specified replacement configuration, and a set of configuration differences is
generated. The resulting differences are used to replace the configuration. The configuration
replacement operation is usually completed in no more than three passes. To prevent looping behavior
no more than five passes are performed.
You can use the copy source-url running-config privileged EXEC command to copy a stored
configuration file to the running configuration. When using this command as an alternative to the
configure replace target-url privileged EXEC command, note these major differences:
• The copy source-url running-config command is a merge operation and preserves all the commands
from both the source file and the running configuration. This command does not remove commands
from the running configuration that are not present in the source file. In contrast, the configure
replace target-url command removes commands from the running configuration that are not present
in the replacement file and adds commands to the running configuration that are not present.
• You can use a partial configuration file as the source file for the copy source-url running-config
command. You must use a complete configuration file as the replacement file for the configure
replace target-url command.
To Next Page
Loading...
Need help?
General
