Cisco Catalyst 3560-X

1-41
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Appendix 1 Working with the Cisco IOS File System, Configuration Files, and Software Images
Working with Software Images
Note If the switch is not in a stack or if there is no network services module installed, no version compatibility
check is needed.
If a mismatch between the service module and the switch is detected, this syslog message appears:
The FRULink 10G Service Module (C3KX-SM-10G) software version
is incompatible with the IOS software version. Please update
the software. Module is in pass-thru mode.
Service-module-specific features require the IP base or IP services feature set. If the switch is running
the LAN base software feature set, this message appears:
Mar 1 00:01:32.341: %PLATFORM_SM10G-6-LICENSE: FRULink 10G Service Module
(C3KX-SM-10G) features are not supported with this license level. Module is in
pass-thru mode.
You can use the show switch service-module user EXEC command to view a service module on the
switch or any service modules in the stack, and the service module software version supported by the
switch/
This is an example of output when the software versions are compatible:
Switch# show switch service-modules
Switch/Stack supports service module CPU version: 03.00.24
Temperature CPU
Switch# H/W Status (CPU/FPGA) CPU Link Version
-----------------------------------------------------------------
1 OK 86C/70C connected 03.00.24
This is an example of output when a switch with a service module installed is running the LAN base
feature set:
Switch# show switch service-modules
Switch/Stack supports service module CPU version: 03.00.25
Temperature CPU
Switch# H/W Status (CPU/FPGA) CPU Link Version
-----------------------------------------------------------------
1 LB-PASS-THRU * 71C/59C notconnected N/A
* Module services not supported on a Lanbase license