Configuring LED Patterns
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 228
9
LED patterns can be customized for the line keys and attended console keys.
To configure Line Key LED patterns:
STEP 1 Click Admin Login > advanced > Voice > Phone
STEP 2 Under Line Key LED Pattern, configure the parameters to customize the Line Key
LED patterns with the LED script described in the following table:
Firmware downloading Slow blink amber
Firmware upgrading Fast blink amber
Incoming call Fast blink red
Incoming page call Fast blink green
Call holding Slow blink green
Call active (off-hook) Solid green
Message waiting Solid red
Description LED Pattern
Parameters Description
Idle LED The line is idle.
Remote Undefined
LED
The Remote Undefined state pattern, where the shared
call state is undefined (the phone is still waiting for the
state information from the application server). Not
applicable if the call appearance is not shared. Leaving
this entry blank indicates the default value.
Local Seized LED This phone seized the call appearance in preparation for
a new outbound call.
Remote Seized LED
(applicable only to
shared call
appearance)
The shared call appearance was seized by another
phone.
To Next Page
Loading...
Need help?
General
