Cisco SPA IP Phone Field Reference
Regional Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 276
A
SIT3 Tone Alternative to the Reorder Tone played when an
error occurs as a caller makes an outbound call.
The RSC to trigger this tone is configurable on the
IP phone screen.
Defaults to 914@-16,1371@-16,1777@-16;20(.380/
0/1,.380/0/2,.380/0/3,0/4/0)
SIT4 Tone This is an alternative to the Reorder Tone played
when an error occurs as a caller makes an
outbound call. The RSC to trigger this tone is
configurable on the IP phone screen.
Defaults to 985@-16,1371@-16,1777@-16;20(.380/
0/1,.274/0/2,.380/0/3,0/4/0).
MWI Dial Tone Played instead of the Dial Tone when there are
unheard messages in the caller’s mailbox.
Defaults to 350@-19,440@-19;2(.1/.1/1+2);10(*/0/
1+2).
Cfwd Dial Tone Played when all calls are forwarded.
Defaults to 350@-19,440@-19;2(.2/.2/1+2);10(*/0/
1+2).
Holding Tone Informs the local caller that the far end has placed
the call on hold.
Defaults to 600@-19*(.1/.1/1,.1/.1/1,.1/9.5/1).
Conference Tone Played to all parties when a three-way
conference call is in progress.
Defaults to 350@-19;20(.1/.1/1,.1/9.7/1).
Secure Call Indication Tone Played when a call has been successfully
switched to secure mode. It should be played only
for a short while (less than 30 seconds) and at a
reduced level (less than -19 dBm) so it does not
interfere with the conversation.
Defaults to 397@-19,507@-19;15(0/2/0,.2/.1/1,.1/
2.1/2).
Parameter Description
To Next Page
Loading...
Need help?
General
