Z- d e p th
Z-depth is pen width PW
In the HPGL file, widths can be assigned to the pens. If your drawing program supports it, you can
use these values to comfortably adjust the Z depth. Just enter the desired depth as pen width in your
drawing program and select this option.
Z depth different for each pen
If you select this option, you can specify an individual depth for each pen by right-clicking on the
respective pen.
Too l s
If the "Extra tool for each pen" option is selected, you can right-click on the pen in the table above
to select a different tool for each pen.
Feed
Feed is pen speed VS
In a HPGL file, individual speeds can be specified to the pens with the VS command. If your
drawing program supports this, you can specify a speed for each pen when exporting. If you select
this option, then the milling feed is automatically and comfortably taken over by each pin.
Feed for pens is different
With this option, an individual value can be specified for each pen. To do this, click on the desired
pen in the upper list and set the feed individually.
Ze ro Offs e t
This field allows you to specify where the zero point should be at the workpiece. This makes it
possible, regardless of the information in the HPGL file, to move the zero point and thus
comfortably adapt to his workpiece.
To Next Page
