User
Logging in users is required to gain access to certain functions. This is described in „User-Login“
and "Login". This chapter explains the assignment of user rights and passwords. Of course, to be
able to change user rights and passwords, you must have the corresponding rights, normally logged
in as an administrator.
After selecting the currently used user, the "Change password" button becomes active. Pressing this
button opens a small dialog that allows you to enter a password. After entering the current password
(which can be empty if no password was assigned) you can assign a new password.
Whi ch pass w ord?
Both inputs must be identical in order to prevent the password from being changed if it is mistyped.
All numbers, letters and special characters are allowed, the password may be between 0 and 255
characters long. This means that the field may also be empty, which means there is no password
assigned. If you are the only user on the machine, it may make sense not to assign a password. So
you do not have to log in every time. However, if other persons have access to the machine, it
makes sense to block access to prevent unauthorized manipulation.
Forgo t Passw ord
Attention! Be careful not to forget the password. If this has happened, only an
administrator can reset the password.
If this is necessary or if you need to make further adjustments to the machine, please
contact the support of CNC-STEP GmbH & Co. KG.
Language
Here you can change the language later. The change does not (immediately) affect windows that are
already displayed, therefore it is necessary to restart the software to update all translated texts.
To Next Page
Loading...
