So f tlimi ts
By default, the soft limits are always on, that is, after homing has been performed, the machine
"knows" where it stands and how long the axes travel. It is therefore automatically always stopped
before the hitting the stopping point. If the tick is removed before "Soft Limits", this check is
switched off, which is normally only required when testing the machine, if the reference switches
do not (yet) function properly. With soft limits off, you should only drive slowly and carefully. If
the check mark is greyed out, deactivating the soft limits is prohibited (see Machine Configuration
Dialog: Security - Force Soft Limits)
To Next Page
Loading...
