5 Short introduction
This chapter explains the most important steps required to load and execute a CNC program in the
"fast run".
The design of the graphical interface of the software may differ from the design of the illustrations
in this manual. It deliberately chose a "classic design" with few colors to optimize the contrast and
readability of the manual.
Starting the Software
It is best to turn on the machine before starting the software. Otherwise, you will receive an error
message because it will automatically attempt to connect to the controller at startup. If you forgot to
turn it on, you can easily make up for it and click "Retry" a few seconds later.
To Next Page
Loading...
