G ene ra l s etti ngs
Import from Corel-Draw
CorelDraw is a very popular paint program, but unfortunately it generates a very inaccurate export
of data. If you have exported data from CorelDraw, check this box to be able to import the file
correctly.
Save parameters
If you make changes to the pens or global settings, they will be saved and automatically loaded
again on the next import. If you do not want this, remove the check mark and you can change the
data without saving it. By clicking on the button "Reset to default values" all settings are reset to the
default values.
CV-Mode
In CV mode, curving and cornering do not slow down until the machine stops, but, similar to
motorcycling, the "curve is cut". So you get a faster, jerk-free movement, but the path is not 100%
accurate traversed. The maximum permissible error can be changed in the machine settings.
Create line numbers
The NC program thus contains line numbers. This can be useful if you want to interrupt the work
and want to continue again to remember the position.
Metric plot units
Normally, a plotter unit is 0.0254mm, that is 1/1000 inch. But there are also programs, which set
the export only 0.025mm as a unit. That's 1/1016 inches. If your part is not accurate and your
drawing program uses this metric base, check the "Metric plotter units" box.
To Next Page
