9 The configuration menu
Machine
All parameters related to the machine are set here, such as number, resolutions and speeds of the
axis drives, inputs and outputs, jog speeds and other settings. Explaining the meaning of all the
parameters here is beyond the scope of this manual, and in most cases is not necessary because
standard parameter sets are available for machines sold with the software. A brief introduction to
the most important settings can be found in the chapter „Initial-Start-up“. For advanced users and
designers of special machines or self-construction, please refer to the separately available
Reference manual.
It is recommended to make a backup of the parameters before making any changes (see “create
backup", top).
To Next Page
Loading...
