Short description
This manual is intended for users and machine operators. It explains the installation of the hardware
and software, the initial commissioning and the basic steps in the daily handling of the machine. It
is assumed that you already own a working milling machine or engraving machine that you have
purchased together with the CNC control. In this case, the setting of the machine parameters is very
easy and is limited to the selection of a pre-set parameters. The control can also be individually
adapted to a large number of different machines. However, this requires the exact knowledge of the
drive mechanism and the electrical wiring. For advanced users who want to run the control on their
own designs or machines of other manufacturers, refer to the Reference Manual, which describes
parameter setting and macro programming.
To Next Page
Loading...
