13
booted or not.
2.3 Power on
The logo displays when the power is on, and appears the processing screen. After the 3~5 seconds
checking process, the system enters the monitoring main screen and the users can start operations.
Caution
In case of any fatal errors found during the self-detection process, the system will
alarm.
Caution
Check all the available monitoring functions and make sure they work properly.
Caution
If a battery is configured, users must charge the battery after each time of use so as to
ensure sufficient power storage.
Caution
If any monitoring functions are found with damage or there are any error reminders,
don’t use this monitor to monitor patients and quickly contact with the biomedical
engineers of your hospital or maintenance engineers of our Company
Caution
Reboot the equipment at least 1 minute after shut down.
2.4 Connect with Sensor
Connect the required sensor between the monitor and the monitoring position of a patient.
Caution
For correct connection methods and relevant requirements of various sensors, please
refer to Chapters 10-15.
2.5 Check Recorder
If there is recorder in monitor, check the paper. If there is no paper, see reference related in chapter 1.
To Next Page
Loading...