Comen C80 - About ST Monitoring

67
with PR.
6. FILTER,SWEEP ,WAVE COLOR : See this chapter “ECG Settings” parameter area
corresponding
7. NOTCH: When set to ON, it is a method of inhibiting the method and apparatus of the
power frequency common mode interference, for bioelectric signals measurement
system including a common mode interference signal extraction circuit and a drive
circuit connected to the circuit; particular, the apparatus furtherincludes a phase
compensation processing means for receiving from the subject organisms of
biological signals and the driver circuit to provide the amplified signal, the output is
sent to a feedback signal by measuring biometric.
8. HR ALM SETUP: setup heart rate hight limit ,middle limit ,low limit of the upper and
lower limits .
9. ST AMALYSIS : ST Segment Analysis Select this item and enter the “ST Segment
Analysis” menu.
10. ARR ANALYSIS: ARR Analysis Select this item and enter the “ARR Analysis”
menu.
11. ECG CAL : When the ECG calibration, you can not monitor the patient . Tip: in the
middle of the screen of the instrument calibration can not monitor the patient . Stop
the calibration is required to return to the “ECG Setup” select to “stop ECG
calibration” menus .
12. DEFAULT : Select "default configuration" dialog box, the user can choose "No" or
“Yes" to be “the default configuration” or “original configuration will be set”
11.5.4 About ST Monitoring
The monitor performs ST segment analysis on normal and atrially paced beats and calculates ST
segment elevations and depressions. This information can be displayed in the form of ST numerics
and snippets on the monitor.
All available leads can be monitored continuously. The ECG waveform does not need to be
displayed on the Screen for ST segment analysis.
Warning
This monitor provides ST level change information; the clinical significance of the ST
level change information should be determined by a physician.