107
Measurement stopped During measurement users press the START
button to stop measurement
Calibration… Calibration in process
Calibration stopped Calibration completed
Gas leakage detection… Gas leakage detection in process
Gas leakage detection stopped Gas leakage detection is stopped
Module reset… Reset after NIBP module is loaded
Manual reset… NIBP reset (activated by users) in process
Fail to reset Fail to reset
14.8 NIBP alarm information
Provided that the alarming record function under relevant menu is turned on, those physical
alarms activated because parameters exceed alarming limits may activate the recorder to
automatically output alarming parameter values and the relevant measurement waveforms. The
following table lists various possible alarms during NIBP measurement process.
14.9 Maintenance & Cleaning
Warning
Don’t compress the rubber pipe on a cuff.
Keep water or cleaning liquids out of the connector socket in the front of the monitor,
otherwise the equipment may be damaged.
During monitor cleaning, users need only sweep the outer surface of the connector
socket instead of its inner surface.
In case a recyclable cuff is disconnected with the monitor or being cleaned, users should
locate the cover cap above the rubber pipe so as to prevent any liquids from entering
the rubber pipe and being absorbed into the module.
14.9.1 Recyclable blood pressure cuff
Normally cuff may be disinfected within a hot air cabinet under the high pressure, gas or radiation
disinfection methods or sterilized by immersion into decontamination solutions. But users must
take away the rubber bag when applying such methods. Cuff can not be dry washed but machine
washed or hand washed only, and hand wash can extend service life of cuff. Before cleaning, users
should take away the rubber bag and put back after cleaning and cuff drying.
To Next Page
Loading...