36
5.3.4 Paper loading procedures
Open the recorder door;
Pull up the slide switch at the left rod of the recorder;
Load new paper exactly following the paper inlet, with the print side toward the
heat-sensitive head;
Slightly pull the paper exposed from the other side, and align the paper properly;
Pull back the slide switch at the left rod of the recorder;
Remove the paper from the paper outlet of the recorder;
Close the recorder door.
Caution
Paper loading must be done softly so as to avoid heat on the heat sensitive head. Unless
during paper loading or trouble shooting, the recorder door must be kept open.
5.3.5 Solution to paper jam
When the running voice of the recorder sounds improper or paper outputs improperly, users
should open the recorder door to check whether there is paper jam. Procedures to clear paper jam:
Cut the recorder paper at the paper outlet side;
Pull up the slide switch at the left rod of the recorder;
Pull out the recorder paper from the bottom;
Re-load paper.