Compaq ProLiant ML570 User Manual

3-14 Compaq ProLiant ML570 Maintenance and Service Guide
Table 3-2
POST Error Messages
continued
Error Code Audible Beeps Probable Source of Problem Recommended Action
1761-Fixed Disk 1
does not support
Block Mode
None Hard drive error Run the System Configuration
Utility and correct.
1764-Slot x Drive Array – Capacity Expansion Process is temporarily disabled
(followed by any one of these statements):
■ Expansion will resume when Array Accelerator has been reattached.
■ Expansion will resume when Array Accelerator has been replaced.
■ Expansion will resume when Array Accelerator RAM allocation is successful.
■ Expansion will resume when Array Accelerator battery reaches full charge.
■ Expansion will resume when automatic data recovery has been completed.
Reattach or replace array
accelerator, wait until the array
accelerator batteries have
charged, or for Automatic Data
Recovery to complete, as
indicated.
1765-Slot x Drive Array Option ROM Appears to Conflict with an ISA Card. ISA
cards with 16-bit memory cannot be configured in memory range C0000 to DFFFF
along with the SMART-2/E 8-bit Option ROM due to EISA bus limitations. Please
remove or reconfigure the ISA card.
Remove or reconfigure
conflicting ISA cards. Disable
“shared memory” on any ISA
network cards that may be
installed.
1766-Slot x Drive Array requires System ROM Upgrade. Run Systems ROMPaq
Utility.
Run the latest Systems ROMPaq
Utility to upgrade the System
ROMs.
1767-Slot x Drive Array Option ROM is Not Programmed Correctly or may Conflict
with the Memory Address Range of an ISA Card. Check the Memory Address
Configuration of installed ISA Card(s) or run Options ROMPaq Utility to attempt
SMART-2/E Option ROM Reprogramming.
Remove or reconfigure
conflicting ISA cards, especially
any cards that are not
recognized by the System
Configuration Utility. Try
reprogramming the ROM on the
SMART-2/E Controller using the
latest Options ROMPaq
(version 2.29 or higher).
1768-Slot x Drive
Array-Resuming
logical drive
expansion process.
None SMART-2 Controller error No action required. Displays
whenever a controller reset or
power cycle occurs while array
expansion is in progress.
1769-Slot x Drive
Array – Drive(s)
disabled due to
failure during
expand. Select F1 to
continue with logical
drives disabled.
Select F2 to accept
data loss and to
re-enable logical
drives.
None SMART-2 Controller error. Data
has been lost while expanding
the array; therefore, the drives
have been temporarily disabled.
Press F2 to accept the data loss
and re-enable the logical drives.
Restore data from backup.
continued

Compaq ProLiant ML570 Specifications

General

Brand	Compaq
Model	ProLiant ML570
Category	Server
Language	English