Installation – RF Path Elements P/N 709C011801 Page 108
8. For RAU configurations with RxU module (see Figure 5-66) :
• EXTERNAL ANT. – for installations above acoustic ceiling requiring external antennas; QMA connector;
• RF FILTER – (QMA) External Filter connections (if required by site planner; refer to section 5.2.3)
Figure 5-66. RxU module Interfaces
9. For configurations with GEM module (see Figure 5-71):
• Fiber connections - connect fiber to SFP module ports as follows:
o If using fiber terminated with LC APC (green) – connect to pre-inserted APC to UPC adapters
o If using fiber terminated with LC UPC connector (blue) – remove pre-inserted APC to UPC adapters and connect
directly to SFP module ports
• Connect the A and B Ethernet ports to the PoE clients using Ethernet cables.
Note: A and B Ethernet ports - 10/100/1000BASE-T with 802.3at compliant Power over Ethernet (PoE+) PSE port
Figure 5-67. GEM Module Interfaces (SFP Module Shown without Adapters)
To Next Page
Loading...
