DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
103
The fields that can be configured or displayed for IGMP Snooping Groups Table are described below:
Parameter Description
VID
Click the radio button and enter a VLAN ID of the multicast group. The range is
from 1 to 4094.
Group Address
Click the radio button and enter an IP multicast group address.
FM
Displays the filter mode. The following can be displayed:
• EX (Exclude) - The filter mode is Exclude.
• IN (Include) - The filter mode is Include.
Exp (sec)
Displays the time left in seconds before the entry expires.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to view all the entries.
IGMP Snooping Mrouter Settings
This window is used to display and configure the IGMP Snooping Mrouter settings.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping
Mrouter Settings, as shown below:
Figure 5-48 IGMP Snooping Mrouter Settings Window
The fields that can be configured in IGMP Snooping Mrouter Settings are described below:
Parameter Description
VID
Enter the VLAN ID used here. The range is from 1 to 4094.
Configuration Select the port configuration. Options to choose from are Port, and Forbidden
Port.
• Port - Select to have the configured ports to be static multicast router ports.
• Forbidden Port - Select to have the configured ports not to be multicast
router ports.
From Port - To Port
Select the appropriate port range used for the configuration here.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
To Next Page
Loading...
