xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 2- 103. About window
NOTE: Upon this firmware release, some functions of the SIM can only be
configured through the Command Line Interface. See the DGS-3600
Series CLI Refence Guide for more information on SIM and its
configurations.
Firmware Upgrade
This screen is used to upgrade firmware from the Commander Switch to the Member Switch. Member Switches will be listed in
the table and will be specified by Port (port on the CS where the MS resides), MAC Address, Model Name and Version. To
specify a certain Switch for firmware download, click its corresponding check box under the Port heading. To update the firm-
ware, enter the Server IP Address where the firmware resides and enter the Path/Filename of the firmware. Click Download to
initiate the file transfer.
To view this window, click Administration > Single IP Management Settings > Firmware Upgrade, as shown below:
Figure 2- 104. Firmware Upgrade window
Configuration File Backup/Restore
This screen is used to upgrade configuration files from the Commander Switch to the Member Switch using a TFTP server.
Member Switches will be listed in the table and will be specified by Port (port on the CS where the MS resides), MAC Address,
Model Name and Version. To specify a certain Switch for upgrading configuration files, click its corresponding radio button
under the Port heading. To update the configuration file, enter the Server IP Address where the file resides and enter the
Path/Filename of the configuration file. Click Download to initiate the file transfer from a TFTP server to the Switch. Click
Upload to backup the configuration file to a TFTP server.
88
To Next Page
Loading...
Need help?
General