xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
SNTP Settings
Time Settings
This window is used to configure the time settings for the Switch.
To view this window, click Administration > SNTP Settings > Time Settings, as shown below:
Figure 2- 30. Time Settings window
The following parameters can be set or are displayed:
Parameter Description
Current Time
System Boot Time
Displays the time when the Switch was initially started for this session.
Current Time
Displays the Current Time set on the Switch.
Time Source
Displays the time source for the system.
SNTP Settings
SNTP State
Use this pull-down menu to Enabled or Disabled SNTP.
SNTP Primary Server
This is the IP address of the primary server the SNTP information will be taken from.
SNTP Secondary
Server
This is the IP address of the secondary server the SNTP information will be taken from.
SNTP Poll Interval in
Seconds (30-99999)
This is the interval, in seconds, between requests for updated SNTP information.
Set Current Time
Year
Enter the current year to update the system clock.
Month
Enter the current month to update the system clock.
32
To Next Page
Loading...
Need help?
General