xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
BGP Neighbor General & Timer Settings
This window is used to configure the BGP neighbor’s general and timer settings.
To view this window, click L3 Features > BGP > BGP Neighbor General & Timer Settings, as shown below:
Figure 4- 139. BGP Neighbor General Settings window
To configure BGP neighbor general settings on the Switch, complete the following fields:
Parameter Description
BGP Neighbor General Settings
IP Address
Enter the IP address of the neighbor to be configured.
Peer Group Name
Enter the peer group to be configured.
Send Community
Toggle between Standard and None. This specifies the communities attribute to be sent to
the BGP neighbor. Standard means only standard communities will be sent and None means
no communities will be sent. The default value is None.
Next Hop Self
Enable or disable the next hop self attribute. By default, this setting is Disabled
Soft Reconfiguration
Inbound
Enable or disable the inbound soft reconfiguration function. By default, this setting is
Disabled.
Remove Private AS
If this setting is set to Enabled, the private AS number in the AS path attribute of the BGP
update packets will be dropped. By default, the setting is Disabled.
Allowas In
If this is Enabled, the BGP router’s self AS is allowed in the AS path list. By default, this
280
To Next Page
Loading...
Need help?
General