xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Trap Source Interface Settings
This window is used to configure the trap source interface settings.
To view this window, click Administration > Trap Source Interface Settings, as shown below:
Figure 2- 80. Trap Source Interface Settings window
The following parameters can be configured:
Parameter Description
Interface Name
Enter a name of the interface.
IPv4 Address
Tick the check box and enter an IPv4 address.
IPv6 Address
Tick the check box and enter an IPv6 address.
Click Apply to implement the changes. To remove an entry, click the corresponding button.
72
To Next Page
Loading...
Need help?
General