xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Trace Route IPv6 Route
To view this window, click Monitoring > Trace Route > Trace IPv6 Route, as shown below:
Figure 8- 37. Trace IPv6 Route window
To trace the route of a packet, set the following parameters located in this window, and click Start.
Parameter Description
Target IPv6
Address
Enter the IP address of the computer to be traced.
TTL (1-60)
The time to live value of the trace route request. This is the maximum number of routers the
traceroute command will cross while seeking the network path between two devices.
Port (30000-64900)
The virtual port number. The port number must be above 1024.The value range is from 30000
to 64900.
Timeout (1-65535)
Defines the time-out period while waiting for a response from the remote device. The user may
choose an entry between 1 and 65535 seconds.
Probe (1-9)
The probe value is the number of times the Switch will send probe packets to the next hop on
the intended traceroute path. The default is 1.
450
To Next Page
Loading...
Need help?
General