xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
BGP Neighbor Settings
This window is used to configure a Border Gateway Protocol (BGP) neighbor.
To view this window, click L3 Features > BGP > BGP Neighbor Settings, as shown below:
Figure 4- 138. BGP Neighbor Peer Group Settings window
To configure BGP neighbor peer group settings on the Switch, complete the following fields:
Parameter Description
BGP Neighbor Peer Group Settings
Peer Group Name
Enter the name of the BGP peer group.
BGP Neighbor Settings
IP Address
Enter the IP address of the BGP speaking neighbor.
Remote AS Number
(1-65535)
Enter the number of autonomous systems to which the peer group belongs to. The range is
from 1 to 65535.
Peer Group Name
Enter the name of the BGP peer group.
278
To Next Page
Loading...
Need help?
General