xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Command Logging Settings
This window is used to enable or disable command logging settings.
To view this window, click Administration > Command Logging Settings, as shown below:
Figure 2- 29. Command Logging Settings window
The following parameters are displayed or can be configured:
Parameter Description
Command
Logging State
Enable or disable command logging settings. The default is Disabled.
Click Apply to implement the changes.
NOTE: When the Switch is undergoing the booting procedure, all configuration
commands will not be logged. When the user uses AAA authentication to log in,
the user name should not be changed if the user has used the Enable Admin
function to replace its privilege.
31
To Next Page
Loading...
Need help?
General