xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
IMPB Entry Settings
The table on this window, which is also known as the “IMPB white list,” is used to create Static IP-MAC-Port Binding entries on
the Switch.
To view this window click, Security > IP-MAC-Port Binding > IMPB Entry Settings, as shown below:
Figure 7- 11. IMPB Entry Settings window
The following fields can be set or modified:
Parameter Description
IPv4 Address
Enter the IPv4 address to bind to the MAC address set below.
IPv6 Address
Enter the IPv6 address to bind to the MAC address set below.
MAC Address
Enter the MAC address to bind to the IP Address set above.
Ports
Specify the switch ports for which to configure this IP-MAC-port binding entry (IP Address +
MAC Address). Tick the All Ports check box to configure this entry for all ports on the Switch.
Click Add for implement changes, click Find to search for an entry, click View All for the table to display all entries and click
Delete to remove an entry.
DHCP Snoop Entries
This table is used to view dynamic entries on specific ports. To view particular port settings, select the unit, enter the port number
and click Find. To view all entries click View All, and to delete an entry, click Clear.
To view this window click, Security > IP-MAC-Port Binding > DHCP Snoop Entries, as shown below:
Figure 7- 12. DHCP Snoop Entries window
The following fields can be set:
Parameter Description
Unit - Port
Use the pull-down menu to choose the Switch ID number of the Switch in the switch stack and
354
To Next Page
Loading...
Need help?
General