xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Password Encryption
This window is used to set the password encryption state.
To view this window, click Administration > Password Encryption, as shown below:
Figure 2- 19. Password Encryption window
The following parameters can be configured:
Parameter Description
Encryption State
Use the pull-down menu to enable or disable the password encryption. Select Enabled to
change the password into encrypted form. When password encryption is Disabled, the
password will be in plain text form. However, if the user specifies the password in encrypted
form, or if the password has been converted to encrypted form by the last enable password
encryption command in the CLI, the password will still be in encrypted form and cannot be
reverted back to plaintext form.
Click Apply to implement the changes.
23
To Next Page
Loading...
Need help?
General