xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
The window shown below is the CPU Interface Filtering Configuration for IP window.
Figure 6- 27. CPU Interface Filtering Configuration window (IP)
The following parameters can be modified:
Parameter Description
Profile ID (1-5)
Type in a unique identifier number for this profile set. This value can be set from 1 to 5.
Type Select profile based on Ethernet (MAC Address), IP address or Packet Content Mask or
IPv6 address. This will change the menu according to the requirements for the type of
profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
Select IP to instruct the Switch to examine the IP address in each frame's header.
Select Packet Content Mask to specify a mask to hide the content of the packet
header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame's
header.
VLAN Selecting this option instructs the Switch to examine the VLAN part of each packet header
and use this as the criterion, or part of the criterion for forwarding.
Source IP Mask
Enter an IP address mask for the source IP address.
Destination IP Mask
Enter an IP address mask for the destination IP address.
DSCP Selecting this option instructs the Switch to examine the DiffServ Code part of each packet
header and use this as the, or part of the criterion for forwarding.
Protocol Selecting this option instructs the Switch to examine the protocol type value in each frame's
329
To Next Page
Loading...
Need help?
General