xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 7- 35. WAC Port Settings window
The following parameters can be configured:
Parameter Description
Unit
Use the drop-down menu to select the unit to configure.
From/To
Enter the range of ports to configure.
State
Enable or disable the WAC port settings on the specified ports.
Aging Time (1-1440
min)
This parameter specifies the period of time a host will keep in authenticated state after it
succeeds to authenticate. Enter a value between 0 and 1440 minutes. The default setting
is 1440 minutes. To maintain a constant Port Configuration tick the Infinite box in the WAC
configuration window.
Idle Time (1-1440 min)
This parameter specifies the period of time during which there is no traffic for an
authenticated host and the host will be moved back to the unauthenticated state. Enter a
value between 1 and 1440 minutes. A value of Infinite indicates the Idle state of the
authenticated host on the port will never be checked. The default setting is Infinite.
Block Time (0-300
sec)
This parameter specifies the period of time a host will keep in a blocked state after it fails
to authenticate. Enter a value between 0 and 300 seconds. The default setting is 0
seconds.
Click Apply to implement the changes.
373
To Next Page
Loading...
Need help?
General