Danfoss FC 300

FC 300 Design Guide
How to Program
This parameter cannot be adjusted while
the motor is running.
1-93 Thermistor Source
Option:
*
None [0]
Analog input 53 [1]
Analog input 54 [2]
Digital input 18 [3]
Digital input 19 [4]
Digital input 32 [5]
Digital input 33 [6]
Function:
Select the input to which the thermistor (PTC
sensor) should be connected. An analog input option
[1] or [2] cannot be selected if the analog input
is alrea dy in use as a reference source (selected
in par. 3-15 Reference Source 1, 3-16 Reference
Source 2or3-17ReferenceSource3).
This parameter cannot be adjusted while
the motor is running.
*
default setting ()display text []value for use in communication via serial communication port
172
MG.33.B
6.22 - V LT is a registered Danfoss trademark