Danfoss FC 300 Design Guide

FC 300 Design Guide
How to Program
Function:
Select which reaction the adjus table frequency drive
should take if a fault en coder signal is d etected.
The encoder function in par. 17-61 is an electrical
check of the hardware circuit in the encoder system.
*
default setting ()display text []value for use in communication via serial communication port
253
MG.33.B
6.22 - V LT is a registered Danfoss trademark

Danfoss FC 300 Specifications

General

Enclosure	IP20
Approvals	cUL, UL, CE
EMC filter	Built-in
Communication Options	CANopen, PROFIBUS DP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Output Voltage	0-100% of supply voltage