Danfoss FC 300

FC 300 Design Guide
FC 300 Selection
Control card, USB serial communication:
USB standard .......................................................................................................... 1.1 (Full speed)
USB plug .................................................................................................... USB type B “device” plug
Connection to PC is carried out via a standard host/device USB cable.
The USB connection is galvanically isolated from the supply voltage (PELV) and other high-voltage termina ls.
The USB connection is n
ot galvanically isolated from protection g round. Only use an isolated
laptop as a PC connection to the USB connector on the FC 3 00 drive.
65
MG.33.B6.22 - VLT is a registered Danfoss trademark