Datalogic DX8210 User Manual

Error Codes and Resolutions
Reference Manual 273
132
No Phase
Error
Error
No Phase "time-
out" is exceeded
(On-Line and
PackTrack
Mode).

- Trigger must
be identified
within a speci
-
fied time.
133
Input 2
Failure
Error
Secondary PS
(photoelectric
sensor) Input
Failure Stuck
Active (Pack
-
Track Mode).
- The scanner
will not go into
trigger.

- No data will
be transmitted
to the Host.
- Check the
alignment of the
photoelectric
sensor.

- Check the
functionality of
the photoelectric
sensor.
- Realign the pho-
toelectric sensor.
- Replace the pho-
toelectric sensor.
135
Encoder
Failure
Error
Phase input
(trigger source)
is activated
while encoder
(tachometer) is
stopped (Pack
-
Track Mode).
- No data will
be transmitted
to the host.

- Scanner(s)
will not read
any barcodes.

- System
receives trig
-
ger cycle when
no encoder sig
-
nal is present.
- Check Diag-
nostics | Monitor
to see if the
scanner is
reporting a con
-
veyor speed (See
section
“Diag-
nostics | Moni-
tor” on page 174
).
- Make sure the
encoder
(tachometer)
wheel is making
a firm contact
with the con
-
veyor.
- Adjust, realign, or
replace the encoder
(tachometer).
157
SD Card
Failure
Error
SC5000 - SD
card cannot be
accessed. The
SD card con
-
tains the
backup files. It
also contains a
copy of the
scanners appli
-
cation software.
This failure is
only in the
SC5000.
- Unit will not
backup or
restore the
parameters.
Try to save the
parameters from
the SC5000 to
the SD card (see
SC5000 System
Controller Refer
-
ence Manual).
- Confirm that the
SD card is seated
properly in the
SC5000.

- Replace SD card
(see SC5000 System
Controller Refer
-
ence Manual).
Error
Code
Descrip-
tion
Sever-
ity
Explanation Symptom Troubleshooting Action required

Datalogic DX8210 Specifications

General

Brand	Datalogic
Model	DX8210
Category	Barcode Reader
Language	English