Modify Settings
Reference Manual 51
Modify Settings
Use the Modify Settings Menu selections during initial setup to configure
your
scanning system. If necessary, you can later make modifications to the con-
figuration using the same menu selections.
“System Information” on page 48
Global Settings
• “Operating Mode” on page 52
• “Barcode Settings Table” on page 66
• “Barcode Configuration” on page 73
• “Serial Ports” on page 97
- “Serial Ports | Main Port” on page 97
- “Aux Serial Port” on page 101
• “Ethernet” on page 103
- “Ethernet | Line Settings” on page 104
- “Ethernet | User Sockets” on page 106
- “Ethernet | Ethernet_IP” on page 110
- “Ethernet | WebSentinel” on page 114
• “Fieldbus” on page 116
• “Messaging” on page 121
- “Messaging | Message Format” on page 122
- “Messaging | Message Builder” on page 134
- “Messaging | Statistics” on page 140
- “Messaging | Protocol Index” on page 142
- “Messaging | Pass-Thru” on page 146
- “Messaging | Diagnostics Messages” on page 148
• “Digital I/O” on page 151
• “Diagnostics” on page 154
• “Energy Saving” on page 158
• “HMI Settings” on page 162
•
To Next Page
Loading...
Need help?
General
