User Interface
110
DX8210 Barcode Scanner
Ethernet | Ethernet_IP
Use the Ethernet I/P window to set up digital inputs and outputs for the barcode
scanner.
To enable or disable Ethernet/IP:
1. In the menu under Modify Settings, na
vigate to Global Settings | Ethernet |
Ethernet/IP. The Ethernet/IP window opens.
2. Enter the appropriate information in the form as described below:
Enable Ethernet/IP
Select the check box to enable Ethernet/IP and reveal the related configuration
options.
Heartbeat Enable
Select from the drop-down; Disable, Enable Unconditioned, or Enable Conditioned.
Heartbeat Settings
Heartbeat Timeout
Enter a time value in seconds to define the amount of time between two message
transmissions. If the input timeout expires and no transmission has occurred, the
Heartbeat message will be transmitted.
Heartbeat Message (max.32 chars)
Click to activate the Text Entry Tool and create heartbeat header text to signal
the beginning of the heartbeat message. Characters from NUL (00H) to ~ (7EH) can
be used.
The Heartbeat Message (header) string must be different from the Heartbeat
Terminator string.
Heartbeat Terminator (max.32 chars)
Click to activate the Text Entry Tool and create Heartbeat Terminator text
to signal the end of the heartbeat message. Characters from NUL (00H) to ~ (7EH)
can be used.
The Heartbeat Terminator string must be different from the Heartbeat
Message (header) string.
Send Failure Bitmap
Select the check box to include a Failure Bitmap in the heartbeat message.
Failure Bitmap Format
Select the format of the Failure Bitmap from the drop-down. Options are; Decimal
(ASCII), Hexidecimal (ASCII), Bitmap (ASCII) and Numeric (Binary).
To Next Page
Loading...
Need help?
General
