Datalogic DX8210 User Manual

Error Codes and Resolutions
Reference Manual 271
Error Codes and Resolutions
Error
Code
Descrip-
tion
Sever-
ity
Explanation Symptom Troubleshooting Action required
1
Node not
respond
-
ing
Error
In a Master/
Slave configura
-
tion, the Master
monitors the
status of the
Slaves in its
network. If a
slave unit fails
to be identified,
the Master will
post this mes
-
sage.
- The scan-
ning tunnel's
no-read rate
increases.

- More than
one slave unit
may be shown
as not
responding.
- In a tunnel
configuration,
the cabling that
connects the
system into to a
network must be
intact or a scan
-
ner will be
reported as not
responding.

- Make sure all
the slave units
are powered on.
- Make sure cables
are connected.

- Check scanners
power source.

- Replace scanner.
80
Node
Reset
Error
In a Master/
Slave configura
-
tion, the Master
monitors the
status of the
Slaves in its
network. If a
Slave resets, it
sends a reset
message to the
Master. The
Master then
posts this error
condition on the
diagnostic
screen.
- The scan-
ning tunnel's
no-read rate
may increase
during the
Slave scan
-
ner's reconnec-
tion.
- This condition
is related to a
slave scanner.
Make sure the
power source of
the slave is not
faulty.
- If condition per-
sists, replace the
scanner.
81
Motor Fail-
ure
Error
The scanner's
mirror wheel
motor has
failed.
- The scanner
will be powered
up but will not
emit laser light
from its exit
window.

- The scanners
motor will not
be spinning.
- Hold your hand
in front of the
scanner to deter
-
mine if the laser
is on.
This is an internal
failure and is not
field serviceable

- Replace scanner.

Datalogic DX8210 Specifications

General

Brand	Datalogic
Model	DX8210
Category	Barcode Reader
Language	English