User Interface
104
DX8210 Barcode Scanner
Ethernet | Line Settings
Use the Line Settings window to define and report the fundamental information
about the system.
To edit the Line Settings:
1. In the menu under Modify Settings, navigate to Global Settings | Ethernet |
Li
ne Settings. The Line Settings window opens.
2. Enter the appropriate information in the form as described below:
Host Network (HOST)
Enable DHCP
Select the check box to cause the IP address parameters to become inactive. They
are then used to display the addresses assigned by a DHCP server.
Host IP Address
Enter the Internet Protocol (IP) network address for ETH2 (Setup) in the field
provided. Consult your network administrator to obtain a new address.Host IP
Netmask
Enter the device subnet mask address in the field provided. Consult your network
administrator to obtain a new address.
Host IP Gateway
Enter the device gateway address in the field provided. Consult your network
administrator to obtain a new address.
Host IP DNS1
Enter the address of the Primary Domain Name System (DNS) in the field provided.
To Next Page
Loading...
Need help?
General
