Troubleshooting
270
DX8210 Barcode Scanner
LED Diagnostic Indication
The STATUS and READY LEDs blink simultaneously to signal the presence of a
failure. Diagnostic message transmission on interfaces can be enabled to pro-
vide details about specific failure conditions.
At the same time one or more LEDs light up according to the following scheme:
In a Master-Slave configuration, all Slave scanner alarms and failures can also be
indicated on the Master by turning on the Master’s GOOD LED. This feature can
be enabled by checking the HMI Settings | LED Settings | Indicate Errors on Mas-
ter parameter.
To Next Page
Loading...
Need help?
General
