Reference Manual xi
Power Supply
This product is intended to be installed by Qualified Personnel only.
This product is intended to be supplied by a
UL listed or CSA Certified Power unit
with “Class 2” or LPS power source.
CSA Certified
CE Compliance
CE marking states the compliance of the product with essential requirements
listed in the applicable European directive. Since the directives and applicable
standards are subject to continuous updates, and since Datalogic promptly
adopts these updates, therefore the EU declaration of conformity is a living doc-
ument. The EU declaration of conformity is available for competent authorities
a
nd customers through Datalogic commercial reference contacts. Since April
20th, 2016 the main European directives applicable to Datalogic products
require inclusion of an adequate analysis and assessment of the risk(s). This
evaluation was carried out in relation to the applicable points of the standards
listed in the Declaration of Conformity. Datalogic products are mainly designed
for integration purposes into more complex systems. For this reason it is under
the responsibility of the system integrator to do a new risk assessment regarding
the final installation.
Disconnect the power supply when installing the device or during maintenance to
avoid unintentional exposure to laser light.
There are no user serviceable parts inside the barco
de scanner. Service should only
be performed by Datalogic trained and certified technicians.
Any violation of the optical parts in particular could result in exposure to Class 3B
laser light.
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
To Next Page
Loading...
Need help?
General
