Delta MH300 Series - Page 155

Chapter 7 Optional AccessoriesMH300
7-90
25. Software brake chopper action level
(Pr.07-00)
26. Speed tracking during start-up (Pr.07-
12)
27. Emergency stop (EF) & force to stop
selection (Pr.07-20)
28. Torque command filter time (Pr.07-24)
29. Slip compensation filter time (Pr.07-25)
30. Torque compensation gain (Pr.07-26)
31. Slip compensation gain (Pr.07-27)
2. SVC Mode
01: Password Decoder
Items
1. Parameter protection password input
(Pr.00-07)
2. Parameter protection password setting
(Pr.00-08)
3. Speed control mode (Pr.00-11)
4. Load selection (Pr.00-16)
5. Carrier frequency (Pr.00-17)
6. Master frequency command source
(AUTO) / Source selection of the PID
target (Pr.00-20)
7. Operation command source (AUTO)
(Pr.00-21)
8. Stop method (Pr.00-22)
9. Digital keypad STOP function (Pr.00-32)
10. Max. operation frequency (Pr.01-00)
11. Output frequency of motor 1 (Pr.01-01)
12. Output voltage of motor 1 (Pr.01-02)
13. Min. output frequency of motor 1
(Pr.01-07)
14. Min. output voltage of motor 1 (Pr.01-08)
15. Output frequency upper limit (Pr.01-10)
16. Output frequency lower limit (Pr.01-11)
17. Acceleration time 1 (Pr.01-12)
18. Deceleration time 1 (Pr.01-13)
19. Full-load current for induction motor 1
(Pr.05-01)
20. Rated power for induction motor 1
(Pr.05-02)
21. Rated speed for induction motor 1
(Pr.05-03)
22. Number of poles for induction motor 1
(Pr.05-04)
23. No-load current for induction motor 1
(Pr.05-05)
24. Over-voltage stall prevention (Pr.06-01)
25. Over-current stall prevention during
acceleration (Pr.06-03)
26. Derating protection (Pr.06-55)
27. Software brake chopper action level
(Pr.07-00)
28. Emergency stop (EF) & force to stop
selection (Pr.07-20)
29. Torque command filter time (Pr.07-24)
30. Slip compensation filter time (Pr.07-25)
31. Slip compensation gain (Pr.07-27)