Delta MH300 Series - Page 238

Chapter 9 Specification
MH300
9-5
230V, three-phase
Frame G I
Model VFD_ _ _ _ _ _ _ _ _SAA 75AMH23AN_ _ 90AMH23AN_ _ 120MH23AN_ _ 146MH23AN_ _
Applicable Motor Output (kW) 18.5 22 30 37 (45) *
3
Applicable Motor Output (HP) 25 30 40 50 (60) *
3
Output Rating
*1
Heavy
Duty
Rated Output Capacity (kVA) 28.9 34.4 46.9 57.8
Rated Output Current (A) 75 90 120 146
Carrier Frequency (kHz)
*2
2–15 (Default: 4)
Normal
Duty
Rated Output Capacity (kVA) 31.6 37.6 51.3 63.3
Rated Output Current (A) 81 102 134 160
Carrier Frequency (kHz)
*2
2–15 (Default: 4)
Input Rating
Rated Input
Current (A)
Heavy Duty 77 92 117 143
Normal Duty 85 103 126 151
Rated Voltage / Frequency Three-phase, 200–240 V
AC
(-15%– +10%), 50 / 60 Hz
Operating Voltage Range (V
AC
) 170–265
Frequency Range (Hz) 47–63
Weight (kg) 11.8 11.8 33 33.5
Cooling Method Fan cooling
EMC Filter Optional Built-in Optional Built-in Optional Built-in Optional Built-in
Ingress Protection Rating
IP20
Table 9-4
NOTE:
1. The default is heavy duty mode.
2. The value of the carrier frequency is set in the factory. To increase the carrier frequency, decrease the current.
See the derating curve diagram in Section 9-6.
3. The value in the parentheses is the applicable motor power under normal duty.
4. When the load is a shock or impact load, use a higher level model.