Delta MH300 Series - Page 262

Chapter 11 Summary of Parameter Settings
MH300
11-3
Pr. Parameter Name Setting Range Default
409: 460 V, 3 Phase, 10 HP
410: 460 V, 3 Phase, 15 HP
411: 460 V, 3 Phase, 20 HP
412: 460 V, 3 Phase, 25 HP
413: 460 V, 3 Phase, 30 HP
414: 460V, 3 Phase, 40 HP
415: 460V, 3 Phase, 50 HP
416: 460V, 3 Phase, 60 HP
417: 460V, 3 Phase, 75 HP
418: 460V, 3 Phase, 100 HP
00-01
AC motor drive rated
current
Display by models
Read only
00-02 Parameter reset
0: No function
1: Write protection for parameters
5: Reset kWh display to 0
6: Reset PLC (including CANopen Master Index)
7: Reset CANopen index (slave)
9: Reset all parameters to defaults with base frequency
at 50 Hz
10: Reset all parameters to defaults with base frequency
at 60 Hz
11: Reset all parameters to defaults with base frequency
at 50 Hz (keep the setting values of user-defined
Pr.13-01–13-50)
12: Reset all parameters to defaults with base frequency
at 60 Hz (keep the setting values of user-defined
Pr.13-01–13-50)
0

00-03 Start-up display selection
0: F (frequency command)
1: H (output frequency)
2: U (multi-function display, see Pr.00-04)
3: A (output current)
0

00-04
Content of Multi-function
display (user-defined)
0: Display the output current from the drive to the motor
(A) (unit: Amps)
1: Display the counter value (c) (unit: CNT)
2: Display the drive’s actual output frequency (H.) (unit: Hz)
3: Display the drive’s DC bus voltage (V) (unit: V
DC
)
4: Display the drive’s output voltage (E) (unit: V
AC
)
5: Display the drive’s output power angle (n) (unit: deg)
6: Display the drive’s output power (P) (unit: kW)
7: Display the motor speed (r) (unit: rpm)
3